Eamo_vxr RMS Regular Messages 3,979 Location Wherever I lay my hat... Drives Slow and low! 29 May 2016 #1 I've a set of rims that are currently powdercoated. Can I just sand down as normal to key it up and primer/colour etc? Or should I get them blasted?
I've a set of rims that are currently powdercoated. Can I just sand down as normal to key it up and primer/colour etc? Or should I get them blasted?
RoniN RMS Regular Messages 4,385 29 May 2016 #2 Yep just key and prime as normal. Most alloys are powder coated and then wet sprayed from new. Cheers
Yep just key and prime as normal. Most alloys are powder coated and then wet sprayed from new. Cheers
weeloaney RMS Regular Messages 19,052 Location Fermanagh Drives Mazda 3 MPS AERO 29 May 2016 #3 As said, just sand them down and paint as normal
pablo RMS Moderator Messages 67,026 Location Glengrimley 29 May 2016 #4 Needed to know this also. Nice one.
Eamo_vxr RMS Regular OP Messages 3,979 Location Wherever I lay my hat... Drives Slow and low! 29 May 2016 Thread Starter #5 What sort of grit shoul I be finishing at before primer? 600 feels pretty good so far.