Project Impreza - heading for 400

[bigsigh]

Had a twin engine subaru for an hour this morning, one in the front and this one in the back

Dropped it in with OD cars, will be bored +0.5mm over and honed to suit the new pistons and then soda blasted.
First time i've used them, looking forward to see the results.

 

[bigsigh]

Wee phone call from Billy this afternoon, engine ready for collection in the morning!
Super fast turnaround, very impressive so far, keen to see the work now

 

[bigsigh]

Block halfs collected this morning, very pleased with how they came out.

Will get them all well washed down now and measured up for bearings

 

[bigsigh]

Little parcels of delight

ACL Race big end bearing set,
ACL Race main bearing set,
Mahle Motorsport ring set
Subaru OEM crankcase gasket and seal set
Courtesy of Davy Murray @ Murray Motorsport

Also got a new dial bore gauge .